Filter
Top Products
22 23
CHAIN TENSIONING
SCREW
Fig. 40
BAR
GROOVE
CHAIN DRIVE LINKS
Fig. 38
MAINTENANCE
CUTTERS
CHAIN ROTATION
CHAIN DRIVE LINKS
Fig. 37
ADJUSTING
PIN
BAR STUDS
CLUTCH
COVER
SPROCKET
Fig. 39
CHAIN TENSIONING
PIN HOLE
n Wear gloves when handling the chain and bar. These
components are sharp and may contain burrs.
n Remove the bar mounting nuts using the scrench pro-
vided.
n Remove the clutch cover.
n Remove the bar and chain from the mounting surface.
n Remove the old chain from the bar.
n Lay out the new saw chain in a loop and straighten any
kinks. The cutters should face in the direction of chain
rotation. If they face backwards, turn the loop over.
n Place the chain drive links into the bar groove as
shown.
BAR
MOUNTING
NUTS