Filter
Top Products
Page 28
TOP PLATE FILING ANGLE
See Figure 55.
■ CORRECT 30° - file holders are marked with guide
marks to align file properly to produce correct top plate
angle.
■ LESS THAN 30° – for cross cutting.
■ MORE THAN 30° – feathered edge dulls quickly.
SIDE PLATE ANGLE
See Figure 56.
■ CORRECT 80
o
– Produced automatically if you use the
correct diameter file in the file holder.
■ HOOK – “Grabs” and dulls quickly, increases the
potential of KICKBACK.
Results from using a file with a diameter too small or a
file held too low.
■ BACKWARD SLOPE – Needs too much feed pressure,
causes excessive wear to the bar and chain.
Results from using a file with a diameter too large or file
held too high.
.025 in.
(0.6 mm)
DEPTH GAUGE
Fig. 57
FLAT FILE
DEPTH GAUGE JOINTER
Fig. 58
MAINTENANCE
INCORRECT
BACKWARD SLOPE
SIDE PLATE FILING ANGLE
Fig. 56
80°
CORRECT
HOOK
INCORRECT
MORE THAN 30°
TOP PLATE FILING ANGLE
LESS THAN 30°
Fig. 55
30°
CORRECT
MAINTAINING DEPTH GAUGE CLEARANCE
See Figures 57, 58, and 59.
■ Maintain the depth gauge at a clearance of .025 in.
(0.6 mm). Use a depth gauge tool for checking the
depth gauge clearances.
■ Every time the chain is filed, check the depth gauge
clearance.
■ Use a flat file and a depth gauge jointer to lower all
gauges uniformly. Use a .025 in. (0.6mm) depth gauge
jointer. After lowering each depth gauge, restore
original shape by rounding the front. Be careful not to
damage adjoining drive links with the edge of the file.
■ Depth gauges must be adjusted with the flat file in the
same direction the adjoining cutter was filed with the
round file. Use care not to contact cutter face with flat
file when adjusting depth gauges.
RESTORE ORIGINAL
SHAPE BY ROUNDING
THE FRONT
Fig. 59