Homelite UT08934D Blower User Manual


 
Page 8
ASSEMBLING THE BLOWER TUBES
See Figure 2.
n Screw the nozzle onto the upper blower tube and tighten
securely. Check tightness after initial run and retighten
if needed.
n Place clamp around the neck of the blower housing outlet.
Do not tighten the wing nut yet.
n Align the locking tab on upper blower tube with the slot in
the blower housing outlet. Push the tube into the housing.
Twist to lock into place.
n Rotate the tube so the nozzle is pointing upward as
shown. Tighten the wing nut securely.
n To remove the tubes, loosen the wing nut on the clamp.
Rotate the tubes to unlock them and then remove them
from the blower housing outlet.
INSTALLING THE VACUUM BAG
See Figures 3 - 4.
n Remove the nozzle and upper blower tube from the
blower.
n Unzip the vacuum bag and place the adaptor inside as
shown.
n Align the locking tab on the bag adapter with the slot in
the blower housing outlet. Push the bag adaptor into the
housing. Twist to lock into place.
n Tighten the wing nut securely.
n Rotate the vacuum bag until the shoulder strap is
upright.
n Make sure the vacuum bag is zipped and closed before
starting the unit.
INSTALLING THE VACUUM TUBES
See Figures 5 - 6.
To install the vacuum tubes:
n Screw the upper and lower vacuum tubes together and
tighten securely.
n Loosen the knob on the inlet cover door and open. Place
the notch in the support arm of the upper vacuum tube
under the hinge of the inlet cover door.
n Push the upper vacuum tube into the blower housing.
n Align the upper vacuum tube knob with the hole in the
housing and tighten securely.
To remove the vacuum tubes:
n Loosen the upper vacuum tube knob.
n Remove the vacuum tubes from the blower housing.
n Close the inlet cover door and tighten the knob securely.
ASSEMBLY
Fig. 4
INLET COVER
DOOR
KNOB
Fig. 5
Fig. 6
NOTCH IN
SUPPORT ARM
HINGE
UPPER
VACUUM TUBE
KNOB