Filter
Top Products
Page 11
STARTING AND STOPPING
See Figures 6 - 8.
Starting the product differs depending on whether the engine
is cold or warm. Blower should be on a flat, bare surface
for starting.
TO START A COLD ENGINE:
Slowly press the primer bulb seven (7) times.
Rotate the choke dial clockwise to the FULL CHOKE
position.
NOTE: Each choke position is identified by a detent in
the housing.
Squeeze the throttle trigger fully and hold. Press trigger
lock button in and release throttle trigger.
Pull the starter grip sharply until engine attempts to run
(no more than 4 pulls).
Rotate the choke dial to the counterclockwise HALF
CHOKE position.
Pull the starter grip sharply until the engine runs.
Allow the engine to run for 10 seconds. Squeeze the
throttle trigger to release the trigger lock.
Rotate the choke dial counterclockwise to the RUN
position.
TO START A WARM ENGINE:
Rotate the choke dial counterclockwise to the RUN
position.
Slowly press the primer bulb seven (7) times.
Pull the starter grip sharply until the engine runs.
TO STOP THE ENGINE:
See Figure 8.
Press and hold the OFF switch until the engine stops.
IF ASSISTANCE IS REQUIRED STARTING
THIS PRODUCT:
Do not return this product to the retail store where it was
purchased. Please call our Customer Service Department
for any issues you may have.
For Help Call: 1-800-242-4672
OPERATION
Fig. 7
Fig. 6
primer
buLb
fuLL
chOke
haLf
chOke
ruN
chOke
diaL
Fig. 8
switch
starter
grip