Filter
Top Products
Page 11 — English
WARNING:
Do not allow familiarity with the product to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
WARNING:
Never direct a water stream toward people or pets, or
any electrical device. Failure to heed this warning could
result in serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
Using cleaning deck: removing dirt and mold from decks
and cement patios
Using spray wand: cleaning cars, boats, motorcycles,
outdoor furniture, grills, and house siding
ADDING DETERGENT TO THE PRESSURE
WASHER
See Figure 9.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.
Disconnect pressure washer from power supply.
Place pressure washer upright on a flat surface.
Remove cap from detergent tank.
Pour detergent into tank until it reaches the maximum fill
level located on the unit.
NOTE: Use a funnel, if needed, to prevent accidental
spilling of the detergent outside the tank. If any detergent
is spilled during the filling process, make sure the unit is
cleaned and dried before proceeding.
Reinstall cap.
OPERATION
STARTING AND STOPPING THE PRESSURE
WASHER
See Figures 10 - 11.
CAUTION:
Do not run the pump without the water supply connected
and turned on.
Connect the garden hose.
Turn the garden hose on then squeeze the high pressure
trigger to relieve air pressure. Once a steady stream of
water appears, release the trigger.
After ensuring the On/Off switch is in the OFF ( O ) posi-
tion, connect the pressure washer to the power supply.
NOTE: For ease of use during operation, you may thread
the electrical cord through the coils of the garden hose
before connecting to power supply.
Press the reset button on the pressure washer’s plug to
make sure the unit is ready for operation.
Press ON ( I ) on the switch to start the motor.
To stop the motor, release the trigger and press OFF
( O ) on the switch.
WARNING:
Hold the handle and wand securely with both hands. Ex-
pect the trigger handle to move when the trigger is pulled
due to reaction forces. Failure to do so could cause loss
of control and injury to yourself and others.
USING THE SPRAY WAND TRIGGER
See Figure 12.
For greater control and safety, keep both hands on the
trigger handle at all times.
Pull back and hold the trigger to operate the pressure
washer.
Release the trigger to stop the flow of water through the
nozzle.
To engage the lock-out:
Push up on the lock-out until it clicks into the slot.
To disengage the lock-out:
Push the lock-out down and into its original position.
For the most effective cleaning, the spray nozzle should be
between 8 in. and 24 in. from the surface to be cleaned. If
the spray is too close it can damage the cleaning surface.