Filter
Top Products
14
101414
ELECTRIC CHAIN SAW
PUSH
TO
SHARPEN
Filing Cutter Depth Gauges
The cutter depth gauge clearance is reduced
as cutters are sharpened. After every second
or third sharpening, reset cutter depth gauges.
1. Place depth gauge tool (.025") firmly
across top of two cutters. Make sure
depth gauge enters slot in depth gauge
tool (see Figure 22).
2. Use medium flat file. File depth gauge
level with depth gauge tool.
3. Remove depth gauge tool. With flat file,
round off front corner of cutter depth
gauge (see Figure 23).
After several hand filings, have authorized
service center or sharpening service ma-
chine sharpen chain. This will insure even
filing.
Figure 22 - Depth Gauge Tool On Chain
Flat File
Depth
Gauge
Slot
Figure 23 - Round Off Front Corner Of
Depth Gauge
Depth
Gauge
Tool
Depth Gauge
Front Corner
.025"
CLEANING AND
MAINTENANCE
Continued
WARNING: Unplug chain saw
from power source before
servicing. Severe injury or death
could occur from electrical shock
or body contact with moving
chain.
WARNING: Cutting edges on
chain are sharp. Use protective
gloves when handling chain.
WARNING: Do not hand-
sharpen this Fast Sharp chain.
Hand-sharpening chain will
increase risk of kickback.
Figure 24 - Turning Sharpener Knob
Keep chain sharp. Your saw will cut faster
and more safely. A dull chain will cause
undue sprocket, guide bar, chain, and motor
wear. If you must force chain into wood and
cutting creates only sawdust with few large
chips, chain is dull.
Follow the steps below to sharpen Fast
Sharp chain. The automatic chain sharpener
sharpens cutter, lowers cutter depth gauge,
and adjusts guard drive link.
1. Adjust saw chain for proper tension (see
Saw Chain Tension Adjustment, page 7).
2. Clean out excess sawdust and wood
chips from drive sprocket area.
3. Turn sharpener knob counterclockwise
until clicking stops (see Figure 24).
4. Turn sharpener knob clockwise until you
hear five distinct clicks.
SHARPENING SAW CHAIN
(Fast Sharp Model)
Figure 25 - Sharpening Fast Sharp Chain
Sharpener
Knob
REPLACING SAW CHAIN
Replace chain when cutters are too worn to
sharpen or when chain breaks. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain. This will maintain proper
driving of chain.
Note:
For proper chain and
drive sprocket, see Replacement Parts and
Accessories, on back cover.
5. Place saw on clean, flat surface.
6. Connect saw to power supply.
7. Hold saw, with both hands in normal
cutting position.
8. Press in switch lockout with right thumb
and squeeze trigger.
9. Gently push on sharpener knob. Saw
must be running for chain to sharpen.
Note:
Sparks appearing shows sharpener
is working (see Figure 25). If no sparks
appear, continue to adjust sharpener one
click at a time. After each click, press
sharpener knob until light flow of sparks
appears.
After several sharpenings, you must turn
sharpener knob more to bring stone into
position.