Filter
Top Products
Caution – Please read all instructions
carefully before operating.
• If you have any concerns regarding your health consult your
doctor before using this product.
• Individuals with pacemakers should consult a doctor before use.
•
Never leave the appliance unattended, especially if children are present.
• Never cover the appliance when it is in operation.
• Do not use this product for more than 20 minutes at a time.
• Extensive use could lead to the products excessive heating
and shorter life. Should this occur, discontinue use and allow the
unit to cool before operating.
• Never use this product directly on swollen or inflamed areas
or skin eruptions.
• Never use this product while in bed.
• This product should never be used by any individual suffering from
any physical ailment that would limit the user’s capacity to operate
the controls.
• This unit should not be used by children without adult supervision.
4
5
Instructions for Use
Blade Alignment
•Your clippers were carefully examined to ensure that the blades
were oiled and aligned before leaving our factory.
• Blades must be realigned if they have been removed for cleaning
or replacement.
•To realign the blades, simply match the upper and bottom blades
teeth up, point for point. (End of top blade teeth should be
approximately .05” or 1.2mm back from bottom blade. Compare
your clipper blades with the sketch.)
• If blade alignment is incorrect, add a few drops of oil to the blades,
turn clipper on for a few moments, turn off and unplug. Loosen
screws slightly and adjust. Tighten screws after blade is aligned.
Oil
•To maintain your clipper in peak condition, the blades should
be oiled before every haircut.
• Do not use hair oil, grease, oil mixed with kerosene or any
solvent. The solvent will evaporate and leave a thick oil which may
slow down the blades motion.
Power Screw
• The power screw permits you to adjust the power. It has been
adjusted before leaving the factory. However, if the voltage in your
home is low, you may need to re-adjust it.
•To adjust, use a screwdriver or a thin coin to turn power screw in
clockwise direction until the arm strikes the coil, making a noise.
Then slowly turn power screw out (counter-clockwise) just until
noise stops. This is maximum power setting.
CAUTION:
All servicing of
this ProClipper
must be
performed by
authorized
HoMedics
service
personnel only.
.05" or
1.2mm
PC-400 12/21/01 12:28 PM Page 5