Filter
Top Products
12
29
30
Fig. 34
Angle transmission (Fig. 35)
Check angle transmission or angle gear for grease level about every
50 hours of operation by removing the grease fi ller plug on the side
of angle transmission.
If no grease can be seen on the fl anks of the gears, fi ll the
transmission with quality lithium based multipurpose grease up to
3/4. Do not completely fi ll the transmission.
Fig. 35
Semi-auto cutting head
Nylon line replacement
(1) Remove the case (31) by fi rmly pushing inward the locking tabs
with your thumbs as shown in Fig. 36.
31
Fig. 36
(2) After removing the case, take out the reel and discard the
remaining line.
(3) Fold the new nylon line unevenly in half as shown in picture.
Hook the U-shaped end of the nylon line into the groove (32) on
the center partition of the reel.
Wind both halves of the line on the reel in the same direction,
keeping each half of the line on its own side of the partition.
(Fig. 37)
32
10 cm
Fig. 37
(4) Push each line into the stopper holes (33), leaving the loose
ends approx. 10 cm in length. (Fig. 38)
10 cm
33
10 cm
Fig. 38
(5) Insert both loose ends of the line through the cord guide (34)
when placing the reel in the case. (Fig. 39)
33
34
Fig. 39
NOTE
When placing a reel in the case, try to line up the stopper holes
(33) with the cord guide (34) for easier line release later.
(6) Place the cover over the case so that the cap locking tabs (35)
on the case meet the long holes (36) on the cover. Then push
the case securely until it clicks into place. (Fig. 40)
36
35
Fig. 40
(7) The initial cutting line length should be approx. 11–14 cm and
should be equal on both sides. (Fig. 41)