Filter
Top Products
English
6
SPECIFICATIONS
Model
CS-350A CS35B
Bar Size 350 mm 350 mm
Voltage (by areas)* (110V, 220V, 230V, 240V)
Power Input* 1140W*
No-Load Chain Speed 450 m/min. (7.5 m/sec.) 10 m/sec. (600 m/min.)
Weight 4.2 kg 5 kg
* Be sure to check the nameplate on product as it is subject to change by areas.
110V, 115V, 120V, 127V,
220V, 230V, 240V
STANDARD ACCESSORIES
(1) Screwdriver ................................................................ 1
(2) Wrench ....................................................................... 1
(3) Oil Feeder (only for CS-350A) ............................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
(1) Chain Saw Oil
(2) Round File
(3) Depth Gauge Jointer
Round File and Depth Gauge Jointer are to be used
for sharpening of chain blades. As to its application,
please refer to the item titled “Sharpening of chain
blade”.
(4) Chain Case
Always keep the chain cover on the chain while
carrying the chain saw or while storing it.
Optional accessories are subject to change without notice.
APPLICATION
⅜ General wood cutting.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Confirm the chain tension
Improper chain tension may result in damage to
the chain and the guide bar, and could cause serious
accident. Always confirm that there is proper tension
on the chain prior to operation.
5. Fill the oil tank with oil
This unit is shipped without oil in the oil tank.
Prior to operation, remove the oil cap and fill the
tank with accessory oil. (CS-350A)
This unit is shipped without oil in the oil tank. Prior
to operation, remove the oil cap and fill the tank
with chain saw oil (sold separately), or SAE 20 or
30 motor oil. (CS35B)
Do not use stained or degraded motor oil. Check
oil reservoir periodically and keep it filled while
running saw.
6. Oiling the guide bar and chain
By pushing the oil button, oil is supplied to the
guide bar and chain. Before starting cutting work,
turn on the saw and push the oil button 3 or 4 times
to ensure that oil is well circulated. (CS-350A)
Automatic chain lubrication (CS35B)
7. It is recommended to use an earth-leakage circuit
breaker or a residual current device.
ADJUSTING THE CHAIN TENSION
1. Loosen the bolt securing the chain cover with the
accessory wrench, as shown in Fig. 1. It is not
necessary to remove the bolt.
2. While lifting the tip of the guide bar, turn the
adjusting screw with the accessory minus-head
screwdriver to adjust the chain tension, as shown
in Fig. 2. The chain tension is increased by turning
PRECAUTIONS ON USING CHAIN SAW
1. Hold the unit firmly with both hands, and be alert
for recoiling which may occur during operation.
2. Pull plug immediately if the cord becomes damaged
or cut.
3. Pitch of chain and No. of drive links are 9.5 mm
× 52.
4. Ensure that the material is free of foreign matter
such as nails.
5. Local regulations may require not to cut sapling.
Ensure that there are no such regulations when
cutting sapling.