Hitachi CG 22EAS (SLP) Trimmer User Manual


 
10
English
Specications
Code No.
Type of
attaching
screw
Direction of
rotation
Size of
attaching
screw
6696454
Female
screw
Counterclockwise
M10×P1.25-
LH
6696597
Female
screw
Clockwise
M8×P1.25-
RH
Applicable nylon cord
Cord diameter: 1/8˝ (Φ3.0 mm) Length: 6.5 ft (2 m)
Cord diameter: 3/22˝ (Φ2.4 mm) Length: 13 ft (4 m)
2. Precautions
The case must be securely attached to the cover.
Check the cover, case and other components for
cracks or other damage.
Check the case and button for wear.
If the wear limit mark (17) on the case is no longer
visible or there is a hole in the bottom (18) of the
button, change the new parts immediately. (Fig.
14)
18
17
Fig. 14
The cutting head must be securely mounted to
the unit’s gear case.
For outstanding performance and reliability,
always use Hitachi nylon cutting line. Never
use wire or other materials that could become a
dangerous projectile.
If the cutting head does not feed cutting line
properly, check that the nylon line and all
components are properly installed. Contact your
Hitachi dealer if you need assistance.
3. Installation (Fig. 15)
Install cutting head on gear case of grass
trimmers/brush cutters. The mounting nut is
left-hand-threaded. Turn clockwise to loosen/
counterclockwise to tighten.
19
Fig. 15
For curved shaft models, the mounting nut is right-
hand-threaded. Turn counterclockwise to loosen/
clockwise to tighten.
NOTE
Since the cutter holder cap is not used here, keep
it for when a metal blade is used, if so equipped.
Insert Allen wrench (19) into the hole of the gear
case in order to lock the cutter holder.
4. Adjusting line length
Set the engine speed as low as possible and tap
the head on the ground. The nylon line will be
drawn out about 1-3/16˝ (3 cm) with each tap.
(Fig. 16)
Fig. 16
Also, you can extend the nylon line by hand but
the engine must be completely stopped. (Fig. 17)
Fig. 17
Adjust the nylon line to the proper length
of 4-11/32˝–5-1/2˝ (11–14) cm before each
operation.