Filter
Top Products
2
598-1319-02
Lamp
Socket
Photocell
Socket
Ignitor
Ballast
Large
Coil
Small
Coil
Red
Red
Black
120V AC
Input
Black
Black
Blue
White
Whit
e
White
White
White
White
White
1. Remove plastic cover.
2. Remove bulb.
3. Remove five screws attaching reflector to fixture housing.
4. Label wires according to wiring diagram.
5. Remove wire nuts from wires. Retain wire nuts to connect re-
placement ballast assembly.
6. Remove two screws and lock washers holding ballast in place.
7. Dispose of used ballast assembly.
8. Connect the replacement ballast assembly following steps 1
through 6 in reverse order.
Ballast assembly can be replaced without the cutting
of any wires. Use of a qualified electrician is recom-
mended.
WARNING: Turn power off at the fuse or circuit
breaker.
Fixture Housing
Ballast
Ballast Retention
Screw
Lock Washer
Reflector
Reflector Screw (x5)
Ballast Assembly Replacement Instructions
Model 2LBL7
Ballast Retention
Bracket