Filter
Top Products
Page 8 of 16 STRATUM™ Model VR1000 P/N: ISVR1000 Rev: M
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN
Tel: 908.351.5400 www.haywardpool.com
The timer events are used to control the ON and OFF times of the Filter Pump,
Booster Pump and Low Speed on a two speed Pump. Dip switch #4 Must be on to
allow the timers to be set. A “YES” will allow the following timer settings.
“YES” 7-day all the week long the pumps will run at the same times.
“NO” Each days timers must be set
The 7-day time clock has two (2) on/off programs per day, while each day only has
one program. All time clocks are selected either as “7-day” or “each day”. If “each day” is selected,
you will need to program “ON” times for every day and “OFF” times for every day, even if you
want them all to be the same. All times are adjusted in 1 minute increments.). If you program the
“ON” time equal to the “OFF” time (“12:01 AM to 11:59 PM”) the output will always be “ON”.
For the Booster pump timer “ON” time equals “OFF” time the pump will always be “OFF”
7 DAY MODE
“YES” will use the timing events currently stored in the VR1000
“NO” will allow setting the timers
Blinking time indicates that the timer is ready to be set.
“Down” will move On time earlier
“UP” will move On time later. Menu/OK to go to next screen.
Blinking time indicates that the timer is ready to be set.
“Down” will move On time earlier
“UP” will move On time later. Menu/OK to go to next screen.
Blinking time indicates that the timer is ready to be set.
“Down” will move On time earlier
“UP” will move On time later. Menu/OK to go to next screen.
Blinking time indicates that the timer is ready to be set.
“Down” will move On time earlier
“UP” will move On time later. Menu/OK to go to next screen.
Low Speed On will only appear if dip switch 3 is “ON”
This will allow setting the timing on the Low speed of a two speed pump.
A “N” will allow setting the On and Off time.
Follow the above instructions for the timer settings.
BST On is the timer for the Booster Pump. To set timer follow the above.
Repeat the above for the second timer cycle. For “OVERNIGHT” operation, set
the first timer cycle starting at midnight (12:01 AM) as the desired “ON” time
and then the desired AM “OFF” time. The second timer cycle should be set
from the desired PM “ON” time to midnight (11:59 PM) as the “OFF” time.
EACH DAY MODE
Note when each day mode is selected the timers must be set on a daily basis.
The week days will be stepped through to allow individual day setting.
Y= 7 DAY MODE
N
= EACH DAY MODE
ON = 04:00 AM
OFF=08:00 PM OK?
SET TIMER
EVENTS? Y/N
Low Speed On=
08:00 AM OK?
Daily On Hour =
4 AM
Daily On Min=
1
Daily Off Hour =
6 AM
Daily Off Min =
0
BST On=04:00PM
Off = 0400 PM OK?
On=0700AM Mon
Off= 0400PM OK?
Tue. = Mon
OK? Y/N