Filter
Top Products
OPERATING THE MOWER
Move the height of cut lever sideways to disengage it from the locking
notch, then push forwards to raise or pull backwards to lower the height
of cut. Release the lever in the required position and ensure that it locks
firmly into one of the seven notch settings.
Always select a height of cut to suit operating conditions. Prevent
engine overloading and blockages by avoiding low cuts in long grass
conditions. Be prepared to make two cuts when the grass is long.
To prevent accidents thoroughly inspect the area and remove all
objects which when contacted by the cutterblade could become
dangerous projectiles. Inspect the area for hidden obstructions
which when contacted by the cutterblade could risk health and
safety. Remember the location of these obstructions and ensure
that you mow around them.
Lift the grassbag through the handlebar and close the rear door to rest
against the rear of the mower.
To empty the grassbag, pour out the grass clippings and shake the
grassbag vigorously to clean the airways. Good grass collection
depends on good air flow through the grassbag. When collecting grass
clippings it is important that the grassbag is emptied regularly to pre-
vent blockages and engine overloading.
Open the rear door and slide the mulcher plug into the rear dicharge
chute. Ensure that the plug is fully inserted and the door is closed.
Mulching finely cuts the grass so that the grass can be easily recycled.
Due to the nutrients that this returns to the soil the lawn will need less
fertilizer.
1.13
Grassbag
Height of Cut
305113
Before Mowing
Mulching