Filter
Top Products
To prevent accidents stop the engine disconnect the spark plug
lead before attempting to carry out maintenance procedures on
the mower.
1. Engine Cowl
2. Carburettor
3. Spark Plug / Lead
4. Muffler Guard
5. Muffler
6. Oil filler Cap/ Dipstick
7. Start Grip
8. Fuel Cap
9. Finger Guard
10. Air Cleaner
Remove two screws securing the engine cowl and remove the cowl to
expose the throttle mechanism on the front of the engine. Loosen the
outer cable clamp screw (1) and move the governor control lever (2) to
the left as far as possible. Insert a large, flat blade screw driver (3) into
the slot in the engine control bracket (4) at the angle shown. Push the
governor control lever to the right until it just touches the screw driver
blade. Move the throttle control lever to the ‘fast’ position (not the
‘choke’ position) and re-tighten the outer cable clamp screw. Replace
the engine cowl.
Should only be made by an authorised Briggs & Stratton dealer. Under
no circumstances should the engine be adjusted to run at a speed in
excess of that shown on the Declaration of Conformity.
MOWER
1.19
1
2
3
4
5
6
7
8
9
10
1
2
3
4
Engine
Throttle Cable Adjustment
Carburettor Adjustments
MAINTENANCE