Filter
Top Products
detergent oil with an API service classication of
SF, SG, SH, SJ, SL, or higher.)
3. Install the dipstick.
Adjusting the Cutting Height
Adjusting the cutting height may bring you into
contact with the moving blade, causing serious
injury.
• Stop the engine and wait for all moving parts
to stop.
• Do not put your ngers under the housing
when adjusting the cutting height.
If the engine has been running, the mufer will
be hot and can severely burn you. Keep away
from the hot mufer.
Adjust the cutting height as desired. Set all four wheels
to the same height.
Note: To raise the mower, move the 2 cutting height
levers forward; to lower the mower, move them both
rearward (Figure 11).
Figure 11
Starting the Engine
1. Firmly push in the primer 3 times with your thumb,
holding the primer in for a second before releasing
it each time (Figure 12).
Figure 12
Note: If the air temperature is below 13°C, rmly
push the primer in 5 times.
2. Hold the blade control bar against the handle
(Figure 13).
Figure 13
3. Pull the recoil starter (Figure 14) or turn the ignition
key as shown in Figure 15 (model 447E only).
Figure 14
9