Filter
Top Products
6 7
SAFETY PRECAUTIONS
Operation cont
Always ensure the blade has stopped, by releasing the
engine stop lever, before tilting the mower for
transportation or crossing surfaces other than grass.
Never operate the machine with defective guards, or with
out safety devices, for example deectors and/or grass
bag in place.
Do not change the engine governor settings or overspeed
the engine.
Start the engine carefully, with feet well away from the
cutterblade and always disengage the rear roller drive
clutch before starting the engine.
Do not tilt the mower when starting the engine.
Do not start the engine when standing in front of the
discharge chute.
Do not put hands or feet near or under rotating parts.
Never pick up, carry the machine or lift the rear deector
while the engine is running.
Never touch the exhaust/exhaust guard or cooling ns
when the engine is hot.
Stop the engine and disconnect the spark plug lead:
- Before clearing blockages or unclogging the dis-
charge chute.
- Before cleaning/checking or working on the ma-
chine.
- After striking a foreign object. Inspect the machine
for damage and ensure necessary repairs are made
before re-starting and operating.
- If the machine starts to vibrate abnormally (check
immediately).
Stop the engine:
- Whenever you leave the mower.
- Before refuelling.
Maintenance & Storage
Keep all nuts, bolts and screws tight to ensure that the
equipment is in safe operating condition.
Frequently check fuel lines and ttings for cracks or
leaks and replace if necessary.
Inspect the exhaust periodically and replace if worn or
leaking.
Never store the mower with petrol in the tank within an
enclosed area where fumes may reach an open ame or
spark.
Allow the engine to cool before storing in any enclosure.
To reduce the re hazard, keep the engine and the
surrounding deck area free of grass, leaves, or excessive
grease.
Check the rear deector and grassbag frequently for wear
or deterioration.
Replace worn or damaged parts for safety.
If the fuel tank has to be drained, this should be done
outdoors and when the engine is cool.
Wear strong work gloves when removing and reassem-
bling the cutterblade.
Control Symbols
Slow Fast
Variable Speed Control
Slow Fast
Engine Stop
STOP
Engine Start
Height of Cut Adjustment
Code 412 only