Filter
Top Products
6 7
Delivery Checklist
Remove the mower from the packaging and check that
the following items have been supplied correctly. If any
items are missing contact, your local Hayter dealer.
1. Engine Handbook. 3. Charger (412).
2. Grassbag. 4. Ignition Key (412).
5. Parts list/D of C. 6. Warranty Reg Card.
To prevent accidents cut off the long ribbon attached to
the grassbag and discard. (Refer g.1)
(491 Only) Note: Prior to rst use please fully charge
the battery for 14 hours. (Refer to battery charging)
Handlebar
Unscrew the handlebar securing knobs sufciently to
allow the handlebar to pivot. Hold the engine stop lever
in towards the handlebar and unfold the handlebar to the
operating position, before releasing. (Refer g.2)
Tighten both handlebar knobs to secure in position.
Take care to ensure that the control cables do not
become snagged at the pivot point.
Grassbag Assembly
Before rst use assemble the grassbag and frame. Slide
the frame (1) into the grassbag (2), ensuring that the han-
dle is above the grassbag as shown. Attach plastic clips
(A), (B), (C) and (D) to the grassbag frame. (Refer g.3)
Raise the rear deector, lower the grassbag and hook in
position. Lower the deector to rest on the grassbag.
Prevent Engine Damage
To prevent engine damage the engine is shipped
without oil or petrol. The engine must be lled with
the correct grade of oil and petrol before starting the
engine. (Refer g.4)
Oil Type
Always use high quality detergent oil classied SAE 30
oil. Never use additives with recommended oil.
To prolong the life of your engine it is important that
the oil is changed after the rst 5 hours of use - Refer to
‘Maintenance Schedule’.
Check Oil Level
Clean around the oil ller cap before removing. With
the mower on a level surface, unscrew and remove the
oil ller - dipstick. Wipe oil from it with a clean cloth.
Screw the oil ller - dipstick back in place, then unscrew
and remove it to check the oil level. (Refer g.5)
The oil level is correct when it is at the full mark on
the dipstick. DO NOT OVERFILL. (Refer g.5)
Fuel Type
Always use clean, fresh unleaded petrol. Purchase fuel
in quantities that can be used within 30 days. Never mix
oil with petrol. For added engine protection Briggs &
Stratton recommend the use of their fuel additive which
is available from an authorised Briggs & Stratton service
dealer.
Fill to base of neck to allow for fuel expansion. Do not
overll the fuel tank. (Refer g.6)
Fig. 3
Fig. 2
Fig. 4
Fig. 5 Fig. 6
Fig. 1
B
A
C
D
1
2
O
I
L
ADD FULL
0.15
Litres
ASSEMBLING THE MOWER / BEFORE STARTING THE MOWER