Filter
Top Products
1.191.19
OPERATING THE MOWER
HEIGHT OF CUT
SAFETY NOTICE Continued
To adjust the height of cut : Grip the lever and pull side-
ways to disengage it from the locking notch, then push for-
wards to raise or pull backwards to lower the height of cut.
Finally release the lever at the required position and ensure
it locks firmly into one of the eight setting notches.
Always select a height of cut to suit operating conditions.
Aim to prevent engine overloading and blockages by avoid-
ing low cuts in long grass conditions. Be prepared to make
two cuts when the grass is long.
WARNING: PREVENT ACCIDENTS Before mowing,
thoroughly inspect the area where the mower is to be
used and remove all stones, sticks, wires, bones and
other foreign objects, which when contacted by the
mower cutterbar could become dangerous projectiles.
Inspect the area for hidden obstructions which when
contacted by the cutterbar could risk health and safety.
Remember the location of these obstructions and ensure
that you mow around them.
CAUTION: Prevent engine damage - DO NOT use the
mower on a slope greater than 20 degrees.
20 MAX.
CS080
CS031
CS219
111-0445(A) 21/10/05 10:26 am Page 1.19