Filter
Top Products
SKU 95745 For technical questions please call 1-800-444-3353. Page 4
Unscrew the battery cover located at the rear of the Spotlight by twisting it counterclockwise.4.
See Figure 1.
battery
cover
5. Located underneath the two batteries is an “Auto/Off” Switch-see Figure 2. Turn the switch to
the “Auto” position. Moving the Switch to “Auto” will automatically turn on the Solar Spotlight
during the night. Check to make sure that the two batteries are installed correctly, then twist the
battery cover back on. See Figure 2.
After the initial charge is set, check to see that the LED Lights are on by viewing the light at 6.
night or in a dark location. If the LED Lights (2) are not lit, check the position of the “Auto”
Switch.
Note: During the day, the Solar Panel converts sunlight into electricity, recharging the batteries.
The amount of light the Solar Panel receives depends on placement of the Solar Spotlights,
geographic location and weather. If the weather is cloudy and the panel did not receive a full
charge, the Solar Spotlights may not achieve the full hours of operating time. They will catch
up on their own after two to three days of full sun.
Insert Nut (4) into nut-shaped hole of Stake (3), then thread in Knob (1) - see Assembly 7.
Diagram.
Warning: Before inserting the Solar Spotlight into the ground, makcertain to choose
an area where there are no underground pipes, cables or other obstructions. Make
certain that the ground is soft enough to accept the Stakes (7). Gently insert them
into the ground making certain that it is in solid. Make certain that the Stake is
completely inserted into the ground to assure full stability for the Solar Spotlight.
The Light Assembly (2) rotates up and down to obtain the best lighting situation. The Solar 8.
Panel pivots on a ball and can be set to a number of different angles to obtain the best angle for
solar power.
Figure 1 Figure 2
Battery Cover
Rev 07e, 08i, 10f