Harbor Freight Tools 92122 Landscape Lighting User Manual


 
Page 4SKU 92122 For technical questions, please call 1-800-444-3353.
MAINTENANCE AND SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
Cleaning, Maintenance, and Lubrication
BEFORE EACH USE,1. inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, and any other condition that
may affect its safe operation.
Periodically, 2. clean external surfaces
of the Light with clean, moist cloth.
For best operation, clean the Solar
Panel on the top of the Cap, so that
the battery will charge efciently.
Change the battery every year.3.
Dispose of the battery in a manner 4.
consistent with State, Local and
Federal laws and regulations. Check
with your local hazardous waste
disposal facility for instructions.
TROUBLESHOOTING
The performance of solar light depends
on the amount of direct sunlight available
during daylight hours. If your solar light
does not operate properly, refer to possible
reasons listed below:
DIM LIGHT:
The On/Off switch contacts may 1.
be poor. Turn the switch on and off
several times to alleviate the problem.
The battery may be low or under-2.
charged. Shadows will prevent the
solar panel from fully absorbing
sunlight, such as tree branches, any
shadow from trees, buildings, etc.
Make sure the lights are located in
an unobstructed location where they
can receive 8 hours of sunlight a day.
Allow the battery to recharge for 2 full,
sunny days. Overcast days will limit
performance.
Dirty solar panel (on top of the Cap). A 3.
dirty solar panel will not allow the unit
to charge and will shorten the life of the
battery. Use a soft, moist cloth to clean
the solar panel. Do not use bleaches or
detergents.
NO LIGHT:
The On/Off switch may be in the OFF 1.
position. Turn it to the ON position.
An external light source (i.e. streetlight, 2.
porch light, ood light) may prevent
the light from automatically turning on
at night. Reposition the Solar Light.
Ensure the photocell of the solar light is
not affected by any other light sources.
Battery may need recharging. Check 3.
the battery to ensure it is connecting
with the terminals.
PLEASE READ THE FOLLOWING
CAREFULLY
The manufacturer and/or distributor has provided
the parts list and assembly diagram in this manual
as a reference tool only. Neither the manufacturer
or distributor makes any representation or warranty
of any kind to the buyer that he or she is qualied
to make any repairs to the product, or that he
or she is qualied to replace any parts of the
product. In fact, the manufacturer and/or distributor
expressly states that all repairs and parts
replacements should be undertaken by certied
and licensed technicians, and not by the buyer.
The buyer assumes all risk and liability arising
out of his or her repairs to the original product or
replacement parts thereto, or arising out of his or
her installation of replacement parts thereto.