Harbor Freight Tools 5655 Utility Vehicle User Manual


  Open as PDF
of 6
 
12.REMOVEADJUSTINGKEYSANDWRENCHES.Besurethatkeysandadjustingwrenches
areremovedfromthetoolormachineworksurfacebeforeoperation.
13.AVOIDUNINTENTIONALSTARTING.Besurethatyouarepreparedtobeginworkbefore
turning the start switch on.
14. STAY ALERT. Watch what you are doing. Do not operate this machine when you are tired.
15. DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF ALCOHOL,
DRUGS, OR PRESCRIPTION MEDICINES.
16. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should
becarefullycheckedtodeterminethatitwilloperateproperlyandperformitsintendedfunction.
Checkforalignmentandbindingofmovingparts,anybrokenpartsormountingxtures,andany
other condition that may affect proper operation. Any part that is damaged should be properly
repairedorreplacedbyaqualiedtechnician.Donotusethetoolifanyswitchdoesnotturnonand
off properly.
17. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use parts and accessories
intended for use with this tool, which are available from Harbor Freight Tools.
SPECIAL WARNINGS WHEN USING THIS VISE
Using this Vise may create special hazards.
Take particular care to safeguard yourself and those around you.
Electrical Safety. Never operate any tool if there is an electrical hazard. Never operate an
electrical tool in wet conditions. Never operate a tool with an improper electrical cord or extension
cord. Never operate an electrical tool unless you are plugged into a properly grounded outlet, which
supplies 110-120Volts. We recommend you only use a circuit which is protected by a 30 amp circuit
breakerorotheramperagerecommendedbythemanufacturer.
Crushing and Marring. Overtightening or using incorrect or dirty jaws can cause damage to your
workpiece.Beforeclampinganythinginthisvise,assurethatthejawsareclean.Iftheworkpieceis
softerthansteel,usesoftjawsorshimsofsoftermaterialtopreventdamagetotheworkpiece.
Hammering. Use caution when hammering anything in or on this vise. Preferably use the ground
anvil on top of the Vise as a hammering surface. Do not hammer on the outer, movable vise jaw,
as this can damage the screw. Use only light hammers on relatively soft material. For heavier
hammering use an anvil designed for the purpose.
Slipping. Periodically check to be sure the workpiece is tight in the Vise.
Twisting, bending,
hammeringandsawingonaworkpiececancauseittobecomelooseinthevise,potentiallycreating
a hazard.
NOTICE: No list of warnings can be all inclusive. The operator must supply
common sense, and operate this tool in a safe manner.
Page 4 SKU # 5655
 previous next