Harbor Freight Tools 47926 Brush Cutter User Manual


 
Twisted Hardened Steel Wire Cup Brush
Item #47926 2-1/2” Wire Cup Brush Item #47927 3” Wire Cup Brush
Usage and Safety Warnings
3491 Mission Oaks Blvd., Camarillo, CA 93011
Copyright 2002 by Harbor Freight Tools
®
. All rights reserved. No portion
of this manual or any artwork contained herein may be reproduced in any
shape or form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Thank you for choosing a Harbor Freight Tools product! For future reference, please complete the
owner’s record below:
Model:_____________________ Purchase Date:_____________________
Save the receipt and these instructions. It is important that you read this entire instruction sheet to
become familiar with this product before you begin using it.
Warning: Always wear ANSI approved safety goggles, full face shield, and dust mask or respirator
when working with the Wire Cup Brush.
Warning: Never exceed the recommended maximum safe speed RPM.
2-1/2” Wire Cup Brush: 12,500 Maximum RPM
3” Wire Cup Brush: 12,500 Maximum RPM
®
Before using the Wire Cup Brush:
1. Inspect the brush and spindle for rust, damage or other kinds of deterioration. Never use the Wire
Cup Brush if damage is noted or if the brush is functioning improperly (losing filaments or is out of
balance).
2. Read and understand all warnings and instructions provided in the instruction manual of the power
grinder being used.
3. Make sure the maximum safe speed RPM on the Wire Cup Brush exceeds the “no load”
speed of the power tool being used.
4. With the power grinder’s electrical cord unplugged, install the Wire Cup Brush securely on the
power grinder.
5. The user of the power grinder, and all spectators in the work area must wear ANSI approved safety
goggles, full face shields and dust masks or respirators.
#47926 / #47927 Page 1
47926 27 Wire Cup Brush man.p65 10/30/03, 1:14 PM1