Filter
Top Products
SKU 40544 For technical questions, please call 1-800-444-3353. Page 4
2. Connect 3-way and 4-way Tube Fittings (2 and 3) as shown below. At each
junction, there is a hole through the side of the Fitting that lines up with the hole
in the side of the Tube. Line up these holes on the inside of the structure and
insert Self-tapping Screws (8), but tighten them only slightly at this time.
3. Drape Tarp (7) over assembled frame and secure the corners (first) onto the
frame using the Ball Tie Downs (4) as shown in 4A, B, and C, below.
4. Once the corners are fastened, place the Ball Tie Downs through the balance
of the metal eyelets as shown in the previous illustration, 4D.
5. Lift one side of the roof and slide in four
Steel Tubes (1). Line up the holes in the
Tubes with the holes in the Fittings and
insert Self-tapping Screws (8), but tighten
them only slightly at this time. When
complete, do the same to the other side.
See illustration to the right.
REV 02/05