Filter
Top Products
12. REMOVE ADJUSTING KEYS AND WRENCHES. Be sure that keys and adjusting wrenches
are removed from the tool or machine work surface before operation.
13. AVOID UNINTENTIONAL STARTING. Be sure that you are prepared to begin work before
turning the start switch on.
14. STAY ALERT. Watch what you are doing. Do not operate this machine when you are tired.
15. DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF ALCOHOL,
DRUGS, OR PRESCRIPTION MEDICINES.
16. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged should
be carefully checked to determine that it will operate properly and perform its intended function.
Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any
other condition that may affect proper operation. Any part that is damaged should be properly
repaired or replaced by a qualified technician. Do not use the tool if any switch does not turn on and
off properly.
17. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical replacement
parts. Use of any other parts will void the warranty. Only use parts and accessories intended for use
with this tool, which are available from Harbor Freight Tools.
SPECIAL WARNINGS WHEN USING THIS LOG SPLITTER
Using this poweful tool may create special hazards.
Take particular care to safeguard yourself and those around you.
Hydraulic systems. Never operate this tool if there is a hazard presented by hydraulic fluid.
Before using the splitter, check for hydraulic leaks. Be sure the tool and your work area are clean and
free of oil spills. Hydraulic fluid can create hazards, causing you to slip and fall, your hands to slip
while using the machine, or fire hazard.
Electrical Safety. Never operate this tool if there is an electrical hazard. Never operate an electrical
tool in wet conditions. Never operate this tool with an improper electrical cord or extension cord.
Never operate this tool unless you are plugged into a properly grounded outlet, which supplies 110-
120Volts, and is protected by a 30 Amp circuit breaker.
Physical Hazards. Log Splitting creates special physical hazards. Never operate this tool unless
you are wearing proper safety gloves, hard-toed shoes and ANSI-approved eye protection. Be careful
of the splinters that will be produced, to avoid puncture injury and potential jamming of the tool.
Never try to split logs which are too large or small to fit properly within the tool. Never attempt to
split logs containing nails, wire or other debris. Clean up as you work; accumulated split wood and
wood chips can create a hazardous work environment. Never continue to work in a cluttered work
area which may cause you to slip, trip or fall. Keep onlookers away from this tool, and never allow
unauthorized persons to operate this tool.
NOTICE: No list of warnings can be all inclusive. The operator must supply common
sense, and operate this tool in a safe manner.
Page 4 SKU # 40318