Filter
Top Products
19
Troubleshooting
Flash times of
Timing LED(or
indoor PCB LED4)
Flash times of
Running LED(or
indoor PCB LED3)
0 1 01 E1 Temperature sensor Ta faulty Sensor disconected,or broken,or
at wrong position,or short circuit
0 2 02 E2 Temperature sensor Te faulty Sensor disconected,or broken,or
at wrong position,or short circuit
0 4 04 F8 EEPROM WRONG Faulty indoor unit PCB
0707E9Abnormal communication
between indoor and outdoor
units
Wrong connection,or the wires be
disconected,or wrong address
setting of indoor unit,or faulty
power supply or faulty PCB
08NO EEROR
CODE DISPLAY
E8 Abnormal communication
between indoor wired controller
and indoor unit PCB
Abnormal communication between
indoor wired controller and indoor
unit PCB
0 12 0C E0 Drainage system abnormal Pump motor disconnected,or at
wrong position,or the float switch
broken down,or the float switch
disconected,or at wrong position.
0 13 OD EF Zero cross sigal wrong Zero cross sigal detected wrong
0 16 10 F3 Indoor mode abnormal Different from outdoor unit mode
2 1 15 / Outdoor unit abnormal
2 2 16 / Outdoor unit abnormal
2 4 18 / Outdoor unit abnormal
2 5 19 / Outdoor unit abnormal
2 7 1B / Outdoor unit abnormal
2 8 1C / Outdoor unit abnormal
2 9 1D / Outdoor unit abnormal
3 0 1E / Outdoor unit abnormal
3 1 1F / Outdoor unit abnormal
3 2 20 / Outdoor unit abnormal
3 3 21 / Outdoor unit abnormal
3 5 23 / Outdoor unit abnormal
3 6 24 / Outdoor unit abnormal
3 7 25 / Outdoor unit abnormal
3 8 26 / Outdoor unit abnormal
3 9 27 / Outdoor unit abnormal
4 3 2B / Outdoor unit abnormal
4 4 2C / Outdoor unit abnormal
4 7 2F / Outdoor unit abnormal
4 8 30 / Outdoor unit abnormal
4 9 31 / Outdoor unit abnormal
5 8 3A / Outdoor unit abnormal
5 9 3B / Outdoor unit abnormal
6 3 3F / Outdoor unit abnormal
6 4 40 / Outdoor unit abnormal
Possible reasons
Refer to the outdoor unit trouble
shooting
list
1. For the indoor failure,only running LED ON remote receiver will indicate.
2. For the outdoor failure,timer LED and running LED will indicate.timer LED of remote receiver stands for ten's place,and running LED stands for one's
place.timer LED will flash firstly,2 seconds later,running LED will flash too. Afer that,4 seconds later,they will flash in turns again.Flash times equals to the
failure code of outdoor plus.
20.For example,failure code of outdoor is 2,the indoor unit should display 22.As a result,timer LED flashes twice firstly,then running LED flashes twice.
3.To get much more details of outdoor unit failure,Please refer to the the outdoor unit trouble shooting list.
Failure code(from receive board) Failure code(from wired
controller)
Failure code(from
panel controller)
Trouble shooting