Filter
Top Products
11
123
1.Press "CLOCK" switch
2.Press " " and " " to regulate the time.
Setting of power failure compensation function
When SW1-6 on PCB of wire controller is OFF, it will be in power failure compensation. If the SW1-6 is ON, it has no
compensation function.
When the power is on after blackout, the unit will return to the former state if compensation function is set. Otherwise, it
will stop. When restarting the unit, press "ON/OFF" switch on wired controller.
Notes
Operation
HIGH
C
ROOM TEMP.
The timing is based on the real time. Thus, the real time should be regulated in advance.
The clock regulation steps are as follows:
3.Press "setting" switch. The setting is achieved.
If not in timing, the screen displays the real time.
If in timing, the screen displays the timing time.
If you want to know the real time, go to the first step.
"CLOCK" flickers, and the time displayed is the real time.
The time increases a minute each time you press " " switch.
The time decreases a minute each time you press " " switch.
HEAT
FAN
OPERATION
MODE
CLOCK UP
MODE FAN SWING
HEALTH
CLOCK
TIMER
CHECK FILTER
RESET
ON/OFF
SET RECOVERY
TEMP
TIME
Present time setting