Filter
Top Products
22
ENGLISH
USING WITH THE FACE MASK
------------------------------------------------
Use
1 Press the »8« button to switch
on the appliance.
– The appliance starts at the
lowest temperature level
which takes 10 minutes to
reach as long as the timer set-
ting has not been changed.
2 Select the required temperature
level with » « (LO = low, HI =
high and PU = pulse higher and
lower temperatures).
Note
7
The LO, HI and PU (»pulse«) set-
tings are based on the original
duration of 10 minutes, as long
as the timer setting has not been
changed.
3 Select the timer setting with » «
(10 up to maximum of
30 minutes).
Note
7
Once the set time has elapsed,
a signal tone is emitted three
times.
4 Press »
8« to switch off the appli-
ance after use.
5 Disconnect the power cord from
the wall socket.
Important note
7
It is advisable to use the LO =
low temperature level. Too hot
steam could cause injury to
your face.
7
Do not hold your face too near
to the mask.
7
We recommend using the
appliance for not longer than
20 minutes per day and not
more than two or three times a
week.
7
You can stop the treatment at
any time, by pressing »
8« to
switch off.
7
Rinse your face with cold water
at the end of each session. Then
you can begin the cosmetic
treatment.
7
Always disconnect the power
plug after use. Leave the appli-
ance to cool down for 10 to
15 minutes.
7
Once it has cooled down,
remove the face mask from the
basic appliance (anti-clockwise -
). Pour the remaining water in
the container down the drain.