Filter
Top Products
Assembly - 66
ASSEMBLY
Install Motion Control Levers
MX15343
1. Remove hardware from control arms.
NOTE: The control lever mounting brackets have six
holes. The levers can be installed in the top four holes,
or for a lower lever position, install the levers in the
lower four holes.
2. Align motion control levers (A) with control arms. Install
hardware and tighten.
3. Check motion control lever alignment.
• Move both motion control levers forward.
Install Seat
1. Remove protective covers from seat screws.
MX15344
2. Pivot seat frame (A) forward until it rests on the hinge
stops.
NOTE: The seat mounting hardware is attached to the
seat plate with tie straps.
3. Install seat (B) to the seat frame, using four 5/16-18
locknuts and heavy flat washers (C). Tighten locknuts to 27
N•m (20 lb-ft).
4. Connect wire harness to seat safety switch (D).
Lubricate Machine
Lubricate all moving parts before operating the machine.
See Lubrication Points in the Service Lubrication section.
Check Mower Deck Level
The mower deck is assembled and adjusted at the factory.
After machine is completely assembled, check the mower
front-to-rear and side-to-side deck level.
Check Safety System
For a complete checkout procedure of the safety interlock
system, see Testing the Safety Interlock System in the
Operating section.
A
C
D
C
A
B