Gravely 994125 Lawn Mower User Manual


 
EN - 27
4. Make sure the wings are facing up and
Install mower blade(s) on unit.
5. Torque bolts to 115 – 160 lbf-ft
(156 – 217 N•m).
FUSE BLOCK
The fuse/relay panel is located behind the
rear access panel, below the control panel.
BATTERY
Cleaning the terminals is the only regular
battery maintenance required.
Remove Battery
1. Shut off engine. Engage parking brake.
Remove the ignition key.
2. Place rear access panel in the service
position.
3. Disconnect cables from battery (negative,
then positive). See Figure 18.
4. Remove hold-down bracket and remove
battery.
Replace Battery
1. Replace battery and secure with hold-
down bracket.
2. Reconnect cables to battery (positive,
then negative). Position boot over
positive terminal.
Clean Battery
Keep battery and terminals clean. Inspect
every 100 operating hours or monthly for best
performance.
1. Remove battery from unit.
2. Clean terminals and battery cable ends
with wire brush.
3. Coat terminals with dielectric grease or
petroleum jelly.
4. Replace battery.
Charging the Battery
Battery Electrolyte First Aid
Follow First Aid directions for contact with
battery fluid.
External Contact: Flush with water.
Eyes: Flush with water for at least
15 minutes and get medical attention
immediately!
Internal Contact: Drink large quantities of
water. Follow with milk of magnesia,
beaten egg or vegetable oil. Get medical
attention immediately!
In case of internal contact, DO NOT induce
vomiting!
WARNING: AVOID INJURY. Read
and understand entire Safety
section before proceeding.
WARNING: Battery posts,
terminals and related accessories
contain lead and lead compounds,
chemicals known to the State of
California to cause cancer and
reproductive harm. Wash hands
after handling.
START/RUN
RELAY
STARTER
SOLENOID
RELAY
OPERATOR
PRESENCE
TIME DELAY
RELAY
PTO
RELAY
10A
CONTROLS
FUSE
20A
CHARGING
FUSE
10A
PTO
FUSE
15A
AUXILIARY
FUSE
10A
TIME DELAY
FUSE
15A
ACCESSORY
FUSE
07700114
Figure 17
Fuse Block Diagram
Harness Main Fuse Location
Figure 18
1. Negative Terminal
2. Positive Terminal
3. Battery
4. Hold Down Bracket
2
3
1
4