Filter
Top Products
EN - 35
Adjust Blade Height
See Figure 32.
Level and pitch the mower with the height
adjusters (3) on each deck lift bracket.
1. Loosen mounting hardware (4) and
trunnion nut (2). Loosen jam nut (5).
2. Turn the adjustment bolt (1) clockwise to
lower the deck or counterclockwise to
raise the deck.
3. Adjust all four corners of the deck to
desired pitch, ensuring that deck is even
side to side and front to back.
4. Tighten jam nut, mounting hardware and
trunnion nut.
CLUTCH ADJUSTMENT
If clutch fails to engage or disengage properly
or begins to make abnormal noise, check the
air gap adjustment at the three inspection
slots. See Figure 33..
To check:
1. Stop engine, remove key and wait for all
hot parts to cool.
2. Measure the air gap between the
armature and the rotor.
• Minimum: A .016" feeler gauge should
slide between armature and rotor with
slight contact.
• Maximum: A .020" feeler gauge should
slide between armature and rotor with
slight contact.
3. Repeat for each inspection slot.
To adjust:
1. If necessary, loosen gap adjustment nuts
until a .016" feeler gauge fits between
armature and rotor.
2. Slide a .020" feeler gauge between
armature and rotor.
3. Tighten gap adjustment nut until there is
slight contact on feeler gauge.
4. Repeat steps 1 – 3 at each inspection
slot.
NOTICE: Adjust air gap as evenly as
possible.
Figure 31
Blade Side-to-Side Level
Blade Front-to-Back Pitch
Front
Left
Rear
Right
Figure 32
1. Adjustment Bolt
2. Deck Lift Trunnion
3. Height Adjuster
4. Mounting Hardware
5. Jam Nut
1
2
3
4
5