Filter
Top Products
6.1
6.2
6.3
6.4
6.5
6.6
6.7
SECTION
6
SET.UP
INSTRUCTIONS
Remove the snowblower
from
the shipping
container.
Fasten the crank
support to the
left
side
of the snowblower
frame with
the two 3/8-
16 x 2.00
hex
bolts and
3/8-16
lock nuts.
Remove the
clamps
from
the
discharge chute.
Put a
film
of
grease
on the bottom
of the discharge
chute.
Set the
discharge chute on
the blower outlet,
aligning the
teeth
with
the
worm.
Replace the clamps.
Slide
the chute
crank
from
the
rear through the top
hole in
the crank suppon.
Slide the
front
end of the
crank
into
the U-joint
of the
worm
gear
assembly and
secure
with
a
hair
pin
cotter.