Gravely 272Z Lawn Mower User Manual


 
17
5. Engage parking brake.
6. Levers must be returned to their original position in
order to operate the unit (Figure 5).
TRANSPORTING UNIT
ALWAYS shut off engine, set parking brake, and
remove key when transporting unit on a truck or trailer.
Tie unit down securely. Do not tie down by linkages,
guards, cables or other parts that may be damaged.
STARTING AND SHUTTING OFF THE
ENGINE
NOTE: DO NOT operate starter more than 15 seconds
per minute, as overheating and damage can occur. If
engine will not start, see Troubleshooting on page 42
or refer to Engine Manual.
NOTE: PTO must be disengaged and parking brake
engaged prior to starting engine.
To start:
1. Insert ignition key (Figure 6).
2. Move throttle control lever to middle position.
NOTE: If engine is cold, move choke control to the on
position. Once engine has started and is warmed up,
move choke control to the off position. If engine is
warm, do not use choke.
3. Turn ignition key to Start (3) position. If engine
does not start in five seconds, release ignition key,
wait, and then repeat. Once engine has started,
ignition key will return to the Run (2) position.
Figure 6
To shut off:
1. Disengage PTO.
2. Set parking brake.
3. Turn ignition key to Off (1) position.
CLEANING AND STORAGE
IMPORTANT: Never spray unit with water or store unit
outdoors. Water can seep into sealed bearings and
reduce component life. Bearings are sealed against dirt
and debris only.
A unit that is excessively dirty should be cleaned
before work starts. Cleaning will occasionally uncover
trouble sources. Dirt and abrasive dust reduce the
efficient work life of parts and can lead to costly
replacement.
Short Term
NEVER spray unit with high-pressure water or store
unit outdoors.
Inspect unit for visible signs of wear, breakage or
damage.
Keep all nuts, bolts and screws properly tightened and
know unit is in safe working condition.
Store unit in a cool, dry protected area.
Long Term
Clean unit thoroughly and lubricate. Touch up all
scratched painted surfaces.
Remove weight from wheels by putting blocks under
frame or axle.
When storing unit for extended periods of time, remove
all fuel from tank and carburetor (run dry). Refer to
Engine Manual.
Clean and charge battery. Charge battery every three
to four weeks when storing unit.
When taking unit out of extended storage:
1. Check for any damage or loose parts. Repair,
replace or tighten hardware before operation,
especially blade attachment bolts.
2. If a preservative fluid was used in fuel tank, drain
and discard. Fill fuel tank with fresh new fuel.
WARNING: AVOID SHARP EDGES which
can cut. Movement of parts can cut off fingers
or a hand. Wrap blades, wear gloves, and use
extreme caution when servicing.
START
RUN
OFF
1
2
3
OF 1750
WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.