Filter
Top Products
2-9 Engine/Blower/Blade Assembly
Installation
Place the engine/blower/blade assembly onto the motor
mount arm assembly (Figure 12). Secure the
engine/blower blade assembly to the motor mount arm
assembly using (4) 5/16"-18 x 1-1/2" hex bolts
P#(K1157) and (4) 5/16"-18 flange nuts P#(K1178).
2-8 Motor Mount Arm Installation
Slide the motor mount arm assembly P#(A0006) (Figure
11) into the outer motor mount tube. Secure the motor
mount arm assembly using (1) detent pin P#(J0248).
2-10 Attaching The Boot To The
Mower Deck
Mounting The Boot Hanger
60” & 72” Boot Plate Mounting Instructions
52” Boot Plate Mounting Instructions
Remove the mower’s deflector shield mount (Figure 13).
Place the boot hanger P#(B0117) in-between the
deflector shield mount and the mower deck. Fasten by
using (3) 3/8”-16 x 1-1/4” HHCS P#(K1192) and the
existing 3/8” nuts. The boot hanger will allow you to
switch from collection to discharge in seconds.
To mount the boot plate P#(B0204) to the boot
P#(E1034(60”) E0006(72”)) use (3) 3/8”-16 x 1” carriage
bolts P#(K1182) and (2) 3/8”-16 flange nuts P#(K1215).
To mount the boot plate P#(B0190) to the boot
P#(E1113) use (2) 3/8”-16 x 3/4” carriage bolts
P#(K1181) and (2) 3/8”-16 flange nuts P#(K1215).
Note: Make certain when bolting the boot and boot plate
together, that the head of the bolt is placed from the
inside of the boot. This will prevent grass from collecting
on the bolts.
Remove the bolts that hold the
deflector shield in place so that the boot rod can fasten
the boot and boot plate to the mower deck. Align the
holes in the boot plate to the holes in the deflector shield
mount and slide the boot rod P#(B2540(60” & 72”)
B0189(52”)) through and fasten using (1) hair pin clip
P#(K0099).
For All Deck Sizes
Note: The Mower’s Deflector Shield Has Been
Removed In The Following Photos For Clarity.
Always have the deflector shield mounted when
mowing.
Figure 13
9
Figure 11
Detent Pin
Figure 12
5/16" x 1-1/2" Bolt
Deflector Shield Mount
Mower Deck
Boot Hanger
Boot
Boot Plate