Graco Inc. 2800 Pressure Washer User Manual


 
9
824–001
Troubleshooting
T
o reduce the risk of serious injury
, including fluid injection and splashing in the eyes, or on the skin, always
follow
Pressure Relief Procedure
on page 5 before proceeding.
WARNING
Problem Cause Solution
Engine
will not start
or is hard to start
No gasoline in fuel tank or carburetor
.
Fill the tank with gasoline, open fuel shut of
f valve.
Check fuel line and carburetor
.
Low oil.
Add to proper level.
Start/Stop switch in Stop position.
Move switch to start position.
W
ater in gasoline or old fuel.
Drain fuel tank and carburetor
. Use new fuel and dry
spark plug.
Choked improperly
. Flooded engine.
Open choke and pull engine several times to clear out
gas. Use a dry sprark plug.
Dirty air cleaner filter
.
Remove and clean.
Spark plug dirty
, wrong gap or wrong
type.
Clean, adjust the gap or replace.
Spray gun closed.
T
rigger spray gun while spraying.
Engine misses or
lacks power
Partially plugged air cleaner filter
.
Remove and clean.
Spark plug dirty
, wrong gap or wrong
plug type.
Clean, adjust the spark plug gap or replace.
Low pressure and/or
pump runs rough
W
orn or wrong size tip.
Replace with tip of proper size.
Inlet filter clogged.
Clean. Check more frequently
.
W
orn packings, abrasives in water or
natural wear
.
Check filter. Replace packings. See PUMP SERVICE,
page 13.
Inadequate water supply
.
Check water flow rate to pump.
Fouled or dirty inlet or discharge valves.
Clean inlet and discharge valve assemblies. Check
filter.
Restricted inlet.
Check garden hose, may be collapsed or kinked.
W
orn inlet or discharge valves.
Replace worn valves. See PUMP SER
VICE, page 13.
Leaking high pressure hose.
Replace high pressure hose.
W
ater leakage from
under pump manifold
W
orn packings.
Install new packings. See PUMP SER
VICE, page 13..
W
ater on oil side of
pump
Humid air condensing inside crankcase.
Change oil as specified in Maintenance, page 8.
W
orn packings.
Install new packings. See PUMP SER
VICE, page 13.
Oil seals leaking.
Install new oil seals. See PUMP SER
VICE, page 13.