Filter
Top Products
INSTALLATION
..
-
.
ii,
..*.
..
'
:'>,
.
'i
,..
,.
..
,.
CHECK FOR
DAMAGE
Check unit for any damage that may have occurred
in
carrier notified immediately.
shipping. Any damage should be noted and the
ELECTRICAL SERVICE
The
1020E
model comes
with
an electric starter box
which is not attached to the
unit.
It
is up to the
starter to the power source.
installer to wire the motor to the starter and the
The electrical service required for the
1020E
is 230V
/
6Ocycle
/
50Amp
/
3 phase. An optional 460V/
60
cycle
/
25
Amp
/
3 phase service may be used with
special instructions from manufacturer.
page
4.
Be sure
that
all wiring is properly grounded
Refer to instrucfion manual for the wiring diagram on
and according to all local and national electrical
codes.
INSTALL SPRAY
GUN
Connect the spray hose to the spray gun by inserting
the pin fitting at the end
of
the hose into the quick
coupler on the gun.
CONNECT
TO
WATER
SUPPLY
Refer to Parts Drawing on page
9.
connection to water supply.
pump
in
a
direct supply system.
Do
not exceed
16O0F(7O0C)watertemperaturetothe
Attach lid
to
tank by drilling four holes
in
tank and use
screws, bolts and washers provided.
Connectahosewithatleast3/4in.(ISmm)l.D.frOm
your water supply to the 3/4 in. garden hose fitting
on the water tank.
Connect tank and pump
with
3/4
in.
I.D.
hose and
clamps provided
with
the
unit.
Place one end of hose on hose barb at
bottom
of
water
tank. Place the other end
of
hose on hose barb
at
pump inlet. Clamp each end with,hose clamp. Pump
module and water tankshould be asclose together as
possible. A maximum distance
of
5
ft.
is recomm-
mended.
801-765
3