Filter
Top Products
8
Assembly
It is necessary to fit the lower handle (2), handle bar (1),
and catcher (5) to the mower.
Assembling the catcher
1. The grass catcher (5) is supplied
in two sections. Locate the top
half on top of the bottom half
and interlock them together by
aligning the lugs and slots and
pushing the halves together until
they click into place.
Attaching the catcher
1. Lift the discharge guard (4) in
order to position the catcher.
2. While lifting the discharge
guard, slide the catcher
into position in adownwards
direction (Fig. 1).
3. Push the catcher down until it
locks into place (Fig. 2).
4. Release the discharge guard to secure the catcher in
place between the 2 ribbed locking notches (Fig. 3).
Note. Always empty the catcher before it has reached maximum
capacity, otherwise it will decrease the performance of the mower.
Attaching the Handles
It is necessary to attach both the lower handle and
handle bars.
1. To attach the lower handle,
first use a spanner to
remove the 4 bolts.
2. Place the lower handle in
position and replace the 4 bolts.
Use the spanner to retighten
the nuts.
3. To attach the handle bar,
first remove the two handle
bar locking knobs (13).
4. Position the handle bar over the lower handle
and insert the two locking knobs, and tighten
to secure the handles together.
Cutting height adjustment
The GMC mower has one lever to easily adjust the
cutting height.
There are 10 height settings.
1. To decrease the cutting height
pull the height adjustment
lever (6) out and move it up a
notch, towards the handlebar.
2. To increase the cutting height
pull the lever out and move it
down a notch, towards
the motor.
1
32