Filter
Top Products
13
Operating in cold temperatures
The ventilation slide cover (7) is factory set for use of the
chain saw in normal temperatures. It can be changed for
use in temperatures around or below freezing point. In this
case the position of slide cover (7) is reversed to allow the
air entering the carburettor to be first warmed by the engine
to increase the efficiency of the operation.
1. Turn off the engine.
2. Loosen top cover knob (12)
and remove cover (11).
3. Remove air filter (8) and
disengage the choke control
(18) from its grommet in the
cylinder cover (6) and also
remove the idle adjustment
screw cover.
4. Remove the four screws that secure the cylinder cover
(6).Three screws are located in the chamber under the
top cover. The fourth screw is located at the top front left-
hand side of the saw.
5. Remove the cylinder cover (6).
6. Remove the slide cover, turn
it the other way round with the
snow crystal symbol at the
top and the sun symbol at the
bottom and replace the slide
cover in the cylinder cover.
Replace the cylinder cover and
restore all other components in
their original positions.
Operation
WARNINGS.
• Always follow the safety instructions given at the front
of this manual. This chain saw must only be used for
cutting wood. It must not be used for cutting other types
of material. Do not use the chain saw as a lever for lifting,
moving or splitting objects.
• Do not attach the chain saw to a fixed stand.
• Do not attach any devices to the chain saw other than
those specified by the manufacturer.
Helpful hints
• Do not force the saw into the cut. Apply only light pressure
whilst running the engine at full throttle.
• If the saw chain gets caught in the cut, do not try to
remove it by twisting the guide or pulling forcibly. Use a
lever or wedge to open up the cut so that the saw chain
is freed.