Filter
Top Products
9
adjustment pedal (15) on the base of the line trimmer
with your foot. Then move the handle downwards to the
desired angle.
Before starting
Before use, check that the tool is in good working
order and that the length of the trimmer line is correct,
as follows:
1. Ensure the switch is in the off position and disconnect
the cable plug from the mains supply.
2. Examine the general condition of the tool. Inspect
the guard, switch, cordset and extension cord. Check
for loose screws, misalignment, binding of moving
parts, improper mounting, broken parts and any
other condition that may affect its safe operation. If
abnormal noise or vibration occurs during operation,
turn the line trimmer off immediately and have the
problem corrected.
3. Ensure that you are on a flat surface and have secure
footing.
4. Check that the line touches or goes beyond the edge of
the guard.
Increasing the cutting line
1. Before starting ensure the
cutting line is the correct
length. Pull the cutting
line to the edge of the
guard (8).
2. If the line is to short push
down on the automatic
feed spool (10) and at
the same time pull the
line out so that it extends
a few centimeters past the edge of the guard.
3. Remove the cover from the
line cutting blade (9).
4. During operation to increase
the cutting line simply
switch the line trimmer off
and then on again, this
with restore the line to the
correct length.
Note. Only remove the cover
from the cutting line blade
when all operational checks have been carried out.
Replace the cover when the line trimmer is not in use.
Switching on and off
1. Connect the extension cord
to power.
2. Press the lock-off button
(4), then press the trigger
switch (3).
3. To switch off, release the
trigger switch.
WARNING. The tool runs for
approximately 5 seconds after it has been switched off.
Let the motor come to a complete standstill before setting
the tool down.
Trimming
WARNING. Make sure that the work area is free of rocks,
debris, lines and other foreign objects.
1. Start the trimmer before approaching the grass to
be cut.
2. The automatic line feed mechanism releases 12mm
from each line when the trimmer reaches a certain
speed. If you need the spool to release more than
12mm of line per side, release the trigger until the
speed falls beyond the trigger point then press the
switch again. As the speed picks up a further 12mm
will be released for both lines.
2
1
3