Filter
Top Products
Unpacking
Due to modern mass production techniques, it is unlikely
that your power tool is faulty or that a part is missing. If
you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Fitting the collection bag
1. Connect the strap (fig A)
onto the hook on the
underside of the blower
vacuum housing (fig B).
2. Attach the push-on plastic
connector (fig C) to the
outlet tube of the housing
(fig D). Push the fitting
of the collection bag
directly onto the outlet
until it “clicks”
into position (fig E).
3. To remove the collection
bag, disconnect the
attachments in the
reverse order.
4. When removing the
fitting on the outlet,
first depress the two
buttons on either side
of the plastic connector
(fig F), and then pull
downwards on the fitting.
Finally, remove the strap
from the hook under the
blow/vacuum tube.
Operation of the blower vac
Prior to using the blower vac, ensure you have read and
understood this instruction manual.
• Ensure you are wearing suitable clothing and also safety
equipment like safety glasses, ear protection and a
mask if necessary.
• Ensure the attachments to the blower vac are correctly
fitted and adjusted.
• Be aware of other people and animals in the area where
you are to be operating the blower vac.
To turn the blower vac on
1. Plug the power cord into
an approved electrical
extension cord, and turn
the extension cord on.
2. Ensuring the blower vac is
directed in a safe direction,
depress the trigger switch
(1) and the blower vac will
start. (fig G).
Be sure to be holding the blower vac firmly on start up.
To turn the blower vac off
To turn the blower vac “off”, simply release the trigger switch.
Important. After you have turned the blower vac off, do
not leave the product until the blower vac has been fully
disconnected from the electrical supply.
To select the blow operation
1. Move the blower/vacuum
selector lever (2) towards
the back of the housing
(fig H).
When the blow operation
is selected, air is drawn up
through the large blow/vac
tube and then expelled at a
much higher velocity in the
8
B
A
C
D
E
F
H
G