Filter
Top Products
9
Filling the fuel tank
WARNING. Always shut off the engine before fuelling.
Never add fuel to a machine with a running or hot engine.
Move at least 9 m (30 ft.) away from the re-fuelling site
before starting engine. Do not smoke when re-fuelling or
operating the blower.
WARNING. Do not use another mixture ratio other than 40:1
and never use pure fuel. Do not use fuel that is more than
2-3 months old. Empty the tank during longer breaks and fill
it up again as soon you wish to use the blower again.
Note. It is normal for smoke to be emitted from a new
engine during and after first use.
1. Place the blower upright on the ground or on a sturdy
bench and wipe any debris from around the fuel cap (7).
2. Unscrew the fuel cap (7) and pour the mixture into the
tank using a funnel (not supplied).
3. Be careful not to spill any mixture. If this happens, wipe
the spill with a clean rag.
4. Start the engine at least three metres away from the area
where the fuel tank has been filled up in order to avoid
any risk of fire.
• Danger of fire and burn injuries.
• Always use extreme care when handling fuel! Fuel is
highly flammable.
• Never attempt to fuel the blower if the fuel system
components are damaged or are leaking.
• Never attempt the refuel the engine while it is running or
still warm, allow it to cool before fuelling.
• Never smoke or light any fires near the blower or fuels.
• Always transport and store fuels in an approved container.
• Never place flammable material close the engine muffler.
• Do not use petrol which contains ethanol or methanol as
it may damage the fuel lines and other engine parts.
• Mix only enough fuel for your immediate needs. If fuel
must be stored longer than 30 days, it should first be
treated with a stabilizer or similar product.
Fitting the safety straps (shoulder and waist)
IMPORTANT. Safety straps must be completely adjusted
before initially starting the blower.
IMPORTANT. Ensure the straps are always used to support
the blower during use.
The blower must be used with the shoulder straps (13) and
waist strap (18) provided.
Note. Adjust the straps first with the device in the off position.
1. Place the shoulder straps on your shoulders and fasten
the waist strap by pushing the buckles together.
2. Set the belt lengths tight for greater safety and comfort
during use.
Operation
IMPORTANT. Do not allow the machine to operate
continuously for a long time. Keep it switched off for
20 minutes for every 30 minutes of operation. Total
operation time in a day should be less than two hours.
Starting the blower
To start the engine, proceed as follows:
For cold starting:
1. Manually press the primer (9)
5 to 6 times or until there are
no air bubbles visible in the fuel
discharge line. This will indicate
that the carburettor is full
2. Close the air filter damper (16).