Filter
Top Products
16 Genie TMZ-50/30 & Genie TMZ-17/10 Part No. 72896
Operator's Manual First Edition • Third Printing
Check the Tires and Wheels
Bodily injury hazard. An over-
inflated tire can explode and may
cause death or serious injury.
Collision Hazard. An excessively
worn tire can cause poor handling
and continued use could result in
tire failure.
Tip-over hazard. Do not use
temporary flat tire repair products.
Maintaining the tires and wheels in good condition
is essential to safe operation and good
performance. Tire and/or wheel failure could result
in a machine tip-over. Component damage may
also result if problems are not discovered and
repaired in a timely fasion.
1 Check the tire surface and sidewalls for cuts,
cracks, punctures and uneven or excessive
tread wear.
Result: Replace the tire if uneven or excessive
tread wear is found.
Tires and wheels must be
replaced with tires and wheels of
the specifications listed.
MAINTENANCE
2 Check each wheel for damage, bends and
cracks.
Result: Replace the wheel if any damage is
found.
3 Check each tire with an air pressure gauge and
add air as needed.
4 Check the torque of each lug nut.
Tires and wheels - ANSI & CSA
Tire size 8-14.5LT
Lug nut torque 80 ft-lbs 108 Nm
Tire pressure (cold) 100 psi 6.9 bar
Tires and wheels - CE
Tire size 215 R14 C 112/110
Lug nut torque 80 ft-lbs 108 Nm
Tire pressure (cold) 65 psi 4.5 bar
Scheduled Maintenance
Maintenance performed quarterly, annually and
every two years must be completed by a person
trained and qualified to perform maintenance on
this machine according to the procedures found in
the service manual for this machine.
Machines that have been out of service for more
than three months must receive the quarterly
inspection before they are put back into service.