Filter
Top Products
6 of 6
15 • 20 • 30 • 48 • 50 kW available accessories
®
Protector™ Series
®
Generac Power Systems, Inc. • S45 W29290 HWY. 59, Waukesha, WI 53189 • generac.com
©2013 Generac Power Systems, Inc. All rights reserved. All specifications are subject to change without notice. Bulletin 0K4729-A Printed in U.S.A. 07/19/13
Model # Product Description
006502-0 Spill Box
The 5-gallon spill box screws into the existing fuel fill port of the base tank. It captures and
contains fuel if over fueling or spilling occurs during the fill process.
006504-0 90% Fuel Level Alarm
The 90% fuel level alarm alerts the fuel fill operator when the tank reaches a 90% fill level by
sounding an audible alarm and triggering an LED warning light.
006505-0 - 15 & 20 kW
006506-0 - 30 & 50 kW
Tank Risers
Tank risers are required in some municipalities to help avoid potential base tank corrosion
caused by mounting on rough surfaces.
006507-0 Fuel Fill Drop Tube
A powder coat painted, steel fuel fill drop tube is required in some municipalities to prevent
sparking due to static electricity buildup, which can be caused by the fuel dropping into the
tank from the fill area. Using a drop tube also results in submerged filling, which increases
the fuel delivery flow rate and reduces vapors, foam and potential tank evaporation.
006513-0 - 15 & 20 kW
006517-0 - 30 kW
006516-0 - 50 kW
Stainless Steel Fuel Lines
Some municipalities require the use of stainless steel fuel lines instead of the standard hoses
provided with the diesel generator products. These stainless steel lines are fire resistant for
additional safety.
006510-0 E-Stop
E-stop allows for immediate fuel shutoff and generator shutdown in the event of an
emergency.
006511-0 Spill Box Drainback Kit
The spill box drainback kit allows fuel that was captured in the 5-gallon spill box to be drained
directly back into the fuel tank to avoid vapors.
006512-0 Lockable Fuel Cap
The cast iron, lockable fuel cap provides the ability to lock the fuel system to prevent
unwanted fuel tampering or fuel siphoning.
006572-0 - 15 & 20 kW
006571-0 - 30 kW
006570-0 - 50 kW
Maintenance Kits
The Protector Maintenance Kits offer all the hardware necessary to perform complete
maintenance on Generac Protector generators.
006560-0 - 15 & 20 kW
006559-0 - 30 kW
006558-0 - 50 kW
Cold Weather Kits
Recommended for generators installed in regions where the temperature regularly falls below
32 °F (0 °C). The Cold Weather Kits consist of a block heater with all necessary mounting
hardware and a battery warmer with a thermostat built into the battery wrap.
006576-0 Fuel Maintenance Kit
The Fuel Maintenance Kit contains everything needed to maintain and clean a diesel fuel
system
005704-0 Paint Kit
If the generator enclosure is scratched or damaged, it is important to touch-up the paint to
protect from future corrosion. The paint kit includes the necessary paint to properly maintain
or touch-up a generator enclosure.
005928-0 Basic Wireless Remote
Completely wireless and battery powered, Generac's wireless remote monitor provides you
with instant status information without ever leaving the house.
005951-0
Advanced Wireless
Remote
Remotely control generator functions with the advanced model's LCD display. In addition to
remote testing of the generator, set the exercise cycle and maintenance interval reminders.
006199-0 PMM Starter Kit
The PMM Starter Kit consists of a 24 VAC, field installed transformer that enables the use
of the 24 VAC Power Management Modules (PMMs) and one PMM. The standard controller
(without starter kit) can control two HVAC loads with no additional hardware. Not compatible
with pre-wired switches.
006186-0
Power Management
Module (50 Amps)
Power Management Modules are used in conjunction with the Smart Switch to increase its
power management capabilities. It gives the Smart Switch additional power management
flexibility not found in any other transfer switch. Not compatible with pre-wired switches.
Note: PMM Starter Kit required.
006463-0 Mobile Link™
Generac's Mobile Link allows you to check the status of your generator from
anywhere that you have access to an Internet connection from a PC or with any
smart device. You will even be notified when a change in the generator’s status
occurs via e-mail or text message. Note: Harness Adapter Kit required.
006478-0 Harness Adapter Kit
The Harness Adapter Kit is required to make liquid-cooled units compatible with
Mobile Link™.