Filter
Top Products
INSTALLATION LAYOUT QT048
1950 [76.77"]
1139 [44.84"]
DOOR TYP
1145.5
[45.1"]
884
[34.8"]
DOOR
TYP
1750 [68.9"] TYP
822
[32.36"]
TYP
381
[15"]
STUB-UP
195.2 [7.69"]
58.5
[2.3"]
850 [33.5"]
FRONT VIEW
REAR VIEW
LEFT SIDE VIEW
TOP VIEW
152.5
[6"]
MIN.
152.5
[6"]
MIN.
152.5
[6"]
MIN.
CONCRETE MOUNTING PAD
(SEE NOTE 1)
13.5 (.53") DIA. MOUNTING
HOLE (4) PLACES, 12.7 (1/2")
DIA. MASONRY ANCHOR
BOLTS RECOMMENDED
1) MINIMUM RECOMMENDED CONCRETE PAD SIZE:1155 (45.5") WIDE X 2255
(88.8") LONG.REFERENCE INSTALLATION GUIDE SUPPLIED WITH UNIT
FOR CONCRETE PAD GUIDELINES.
2) ALLOW SUFFICIENT ROOM ON ALL SIDES OF THE GENERATOR FOR MAINTENANCE
AND SERVICING. THIS UNIT MUST BE INSTALLED IN ACCORDANCE WITH CURRENT
APPLICABLE NFPA 37 AND NFPA 70 STANDARDS AS WELL AS ANY OTHER FEDERAL,
3) CIRCUIT BREAKER INFORMATION:
SEE SPECIFICATION SHEET WITHIN OWNERS MANUAL
VISE ACTION LATCH,
ONE PER DOOR, ONE LIFT-OFF
DOOR PER SIDE OF GENERATOR
AREA
STUB-UP
AREA
STATE AND LOCAL CODES FOR MINIMUM DISTANCES FROM OTHER STRUCTURES.
LIFTING PROVISION
(4) PLACES, SEE NOTE 5 AND
CENTER OF GRAVITY DIMENSIONS
4) INSIDE STUB-UP AREA FOR AC LOAD LEAD CONDUIT CONNECTION, NEUTRAL
5) REFERENCE OWNERS MANUAL FOR LIFTING WARNINGS.
CONNECTION, BATTERY CHARGER 120 VOLT AC (.5 AMP MAX.) CONNECTION, AND
ACCESS TO TRANSFER SWITCH CONTROL WIRES. REMOVE FRONT COVER FOR ACCESS.
CIRCUIT BREAKER
SEE NOTE 3
FRONT COVER
CONTROL PANEL
BATTERY CHARGER IS
ENCLOSED WITHIN
670 [26.38"]
56
[2.2"]
NATURAL GAS LINE CONNECTION
3/4" NPT FEMALE COUPLING
LOCATED ON OPPOSITE SIDE (RH)
EXHAUST MUFFLER
ENCLOSED WITHIN,
SEE NOTE 6
6) REMOVE EITHER LEFT OR RIGHT HAND SIDE PANEL TO ACCESS EXHAUST MUFFLER
FIELD CUT HOLE FOR OUTSIDE CONDUIT
CONNECTION ONLY, SEE NOTE 4A
4A) FIELD CUT HOLE IS ONLY REQUIRED FOR MOUNTING OF GENERATOR ON AN
SEE NOTE 4
SERVICE ITEM ACCESSIBILITY CHART
OIL FILL CAP
OIL DIP STICK
OIL FILTER
OIL DRAIN HOSE
AIR CLEANER ELEMENT
SPARK PLUGS
MUFFLER
FAN BELT
102
[4"]
SERVICE ITEM
RADIATOR DRAIN HOSE
THRU LEFT DOOR
SEE NOTE 6
BATTERY
REFERENCE OWNERS MANUAL FOR PERIODIC
REPLACEMENT PART LISTINGS
AIR INLET
LOUVERS
EXHAUST AND AIR DISCHARGE
LOUVERS - FRONT AND SIDES
152.5
[6"]
MIN.
EXISTING PAD.
THRU RIGHT DOOR
THRU LEFT DOOR
THRU RIGHT DOOR
BOTH DOORS
SEE NOTE 6
AND FAN BELT.
- +
SEE NOTE 4
100
[4"]
TYP
BATTERY 12 VOLT 24F
525 COLD CRANKING AMPS
SHIPPING
WEIGHT
(WOODEN SHIPPING
KG [LBS]
44 [98]
CRATE/SKID)
WEIGHT
(GENSET ONLY)
KG [LBS]
AND GENSET)
WEIGHT (SKID
KG [LBS]
WEIGHT DATA
13.5 (.53") DIA. MOUNTING
HOLE (4) PLACES LOCATED
ON BOTTOM OF GENERATOR
MOUNTING FRAME
REMOVE COVER FOR ACCESS
TO RADIATOR FILL CAP
NATURAL GAS
LINE CONNECTION
3/4" NPT FEMALE
COUPLING
688 [1516]
732 [1614]
793.8
[31.3"]
LOW VOLTAGE
AREA ONLY
91.4
[3.59"]
BOTH DOORS
THRU RIGHT DOOR
THRU LEFT DOOR
LOOSENTIGHTEN
NOTES: