Filter
Top Products
Yourgeneratorrequiressomeassemblyandisreadyfor
useafterit hasbeenproperlyservicedwiththe
recommendedoilandfuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408.
IMPORTANT: Any attempt to run the unit before it has
been serviced with the recommended oil wilt result inan
engine failure.
REMOVE G EN ERATOR
FROM CARTON
• Set the carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
• Carefully open the top flaps of the shippingcarton.
Review"Cold Weather Operation" on page9.
• Cut down corners at one end of carton from top to
bottom and laythat side of carton down flat.
• Removeall packing material, carton fillers, etc.
• Removethe generator from the shipping carton.
INSTALL WHEEL KIT
The wheel kit isdesignedto greatly improvethe portability
of your generator.
NOTE:Wheel kit isnot intendedfor over-the-road use.
You will need a socket wrench with I/2" or 13mm sockets
and a needle-nose plier to installthis kit.
Refer to Figure 2 and install the wheel kit as follows:
• Placethe generator on a hard flat surface.
• Standat the engineend of the generator and gently tilt
the generator forward, high enough to placewooden
blocks beneath the cradle.This will allow you to addthe
wheels.
• Slide the axle through the holes in the brackets provided
on the generator cradle.
• Slide one wheel and flat washer on eachend of the axle.
Make sure the air inflation valve isoutward. Insert both
retaining pins usingthe needle-nose plier.Removethe
wooden blocks.
• Attach the vibration mounts to the support leg with
30mm capscrews,washers and lock nuts.
®
Axle
Wheel
Lock Washer
_20mm
Capscrew
Lock Nut
Retaining Pin
Capscrew