Filter
Top Products
5
1 HDMI Outputs 1-4
Connect an HDMI capable device to any of these output ports. The device
attached to output port 1 will be used to read EDID when the EXTERNAL EDID
mode is selected.
NOTE: All devices connected to any of the output ports must be capable of
accepting at least one resolution listed in the EDID of the device connected to
output port 1 when using the EXTERNAL EDID mode. All devices connected
to any output port must be capable of accepting at least one resolution listed
in the pre-programmed EDID (resolutions are listed on page 9) when using the
INTERNAL EDID mode.
2 HDMI Output Ports 5-8
Connect an HDMI capable device to any of these output ports. Please read the
note above.
3 Audio Channel Selection Switch
This switch will modify the EDID to specify the number of supported audio
channels when using the INTERNAL EDID mode. This setting will not affect the
EDID information when using the EXTERNAL EDID mode.
4 EDID Mode Selection Switch
This switch will control the location of the EDID that will be sent to the source
device. The options are EXTERNAL and INTERNAL. Please see page 6 for
more information.
5 Power Indicator LED
This LED will become active once the included 5V DC power supply has been
properly connected to the unit and a power source.
6 HDMI Input Port
Connect an HDMI source device to this input port. The signal from this port will
be replicated to all HDMI output ports. HDMI 1.3 is supported. Please see the
Operation Notes section on page 2 for supported HDMI 1.3 features.
7 5V DC Power Input Receptacle
Connect the included 5V DC power supply between this receptacle and a power
source. Only use the power supply supplied with this unit.
PANEL DESCRIPTIONS