Filter
Top Products
14
GB
4.2. Operating Instructions for Pressure Sprayer Art. No. 875/879 /880
1. Mix the fluid well.
2. Press the pump handle
P
down slightly, turn to the left and
remove the pump
Q
.
3. Pour the fluid into the container up to the maximum mark
(5 litres).
Please observe the safety and proportioning instructions
provided by the manufacturer of the product you are going
to spray.
4. Tighten the pump again with the pump handle
P
by hand
(do not use pliers).
Risk of injury!
A V Never connect your Pressure Sprayer to an air
compressor.
5. Unlock the pump handle
P
by turning slightly to the left and
pump the pump repeatedly (approx. 30-40 times) until the
operating pressure is reached.
Any excess pressure escapes through the safety valve
R
.
The Pressure Sprayer Art. No. 879/880 features a window with
a scale
S
to help you measure out the appropriate dosage of
fertilisers.The window also allows you to see how much fluid is
left in the container.
4.3. General Operating Instructions for all Pressure Sprayers
(Art. No. 867/869/ 875 /879/ 880)
1. Press the operating switch
T
on the handle.
The Pressure Sprayer begins spraying.
2. Release the operating switch
T
on the handle.
The Pressure Sprayer stops spraying.
Setting the permanent lock:
v Press the permanent lock
U
.
The operating switch
T
is pressed down and stays down.
The spray tube can be swivelled 360° in the hand valve.
1. Unscrew the union nut
1
on the hand valve
2
.
2. Turn the spray tube
3
to the correct position.
3. Tighten the union nut
1
on the hand valve
2
by hand
(do not use pliers).
You can adjust the spray jet from full jet (nozzle closed) to a fine
mist spray (nozzle open).
v Open or close the spray nozzle
V
according to the spray jet
you require.
Filling the container:
Spraying:
Adjusting the spray tube:
Setting the spray jet:
V
U
T
2
1
3
S
R
P
Q