Filter
Top Products
14
GB
Fit Accu:
3. Assembly
1. Insert lower part of bottom upright
1
into upright holders
2
up to stop and
secure with the screws
3
.
2. Push connector
4
from underneath
into upper part of bottom upright
1
.
3. Insert threaded rod
6
from left through
lower parts of central upright
5
,
upper part of bottom upright
1
and
connector
4
right up to the stop.
4. Slide threaded bearing
8
into
clamping lever
7
.
5. Screw clamping lever
7
onto
threaded rod
6
approx. 4 turns.
6. Move clamping lever
7
onto
connector
4
and check whether
clamping lever
7
locks.
7. If clamping lever
7
does not yet
lock, screw another turn onto
threaded rod
6
. Repeat procedure
until clamping lever
7
locks on
connector
4
.
8 Firmly attach bottom part of top
upright
9
to upper parts of central
upright
5
using 2wing nuts
z
m
.
The safety starter lock
B
on the crossbar
9
must then
be on the left.
9. Fix the motor cable
0
to the upright with the two cable clips
A
.
Warning! Short-circuit – fire risk !
A
V Accu-contacts should never be bridged with metal!
The Accu is supplied charged at the factory but may lose charge if
it has been stored for a long time. Charge the Accu before using it
for the first time (see 7. Maintenance
Charging the Accu
).
1. Press Accu cover
C
lightly at the front and open.
2. Insert the Accu
D
into the Accu compartment with the connec-
tions pointing towards the flat plugs
E
.
Warning!
A The polarity +/- and the colours of the connections
on the Accu and the flat cable must match.
V Connect flat cable
E
to the Accu connections,
matching the terminals (see adhesive label on
the Accu).
1. Secure Accu
D
with the retaining strap
F
.
2. Close Accu cover
C
.
Assembling the handle:
7
8
EF
C
D
Do not touch battery acid.
If acid comes in contact with the eyes, wash
out immediately with water and send for a
doctor.
7
4
5
B
9
6
0
A
A
1
z
m
1
2
6
7
7
4
3