Furuno FA-30 Log Splitter User Manual


  Open as PDF
of 3
 
2
4. Turn over the chassis. Then, disconnect mini coaxial wire from J2 on pcb 05P0808A.
5. Unfasten four screws from the rear panel to come free.
6. Pull out the cable assembly from the rear panel. (The rear panel may be dicarded.)
7. Pass the cable assembly to the new rear panel.
8. Connect the plugs and ground wires to original places.
9. Pass two wires (two-core power cable and mini coaxial cable) from pcb 05P0817 on the new
rear panel through the hole on the chassis.
Pass two-core power cable and then mini coaxial cable.
10.Fix the new rear panel to the chassis with original four screws.
05P8080A
H
ole
4. Disconnect mini coaxial wire.
Bottom view
Rear panel
5. Unfasten four screws.
6. Push strongly here and pull out the cable.
 previous