Frigidaire Tumble Action Washers Pressure Washer User Manual


 
6
• Slowly open the dispenser drawer by first sliding the
safety latch to the right, then pulling the drawer out
until it stops.
After adding laundry products, slowly close the
dispenser drawer. Closing the drawer too quickly
could result in early dispensing of the bleach and
fabric softener.
Add measured detergent to the detergent
compartment of the dispenser drawer.
Detergent is flushed from the dispenser at the
beginning of the cycle. Either powdered or liquid
detergent can be used. Liquid detergent will
drain into the washer drum as it is added.
Low sudsing detergent is recommended for this
washer. Use the manufacturer's recommended
amount.
If low sudsing detergent is not available, a reduced
amount of regular detergent may be used. Because
reducing the amount of detergent may reduce
cleaning, it is important to pretreat stains, sort carefully
by color and soil level, and avoid overloading.
Detergent usage may need to be adjusted for water
temperature, water hardness, size and soil level of the
load.
For best results, avoid oversudsing.
If desired, pour the recommended amount of fabric
softener into the compartment labeled "Fabric
Softener" and marked with this symbol .
Dilute concentrated softeners with warm water to the
Fill Line.
Do not exceed the maximum fill line. Overfilling can
cause early dispensing of the fabric softener which
could result in stained clothes.
Use of a fabric softener dispensing ball is not
recommended in tumble action washers.
If desired, measure out the recommended amount of
liquid chlorine bleach (not to exceed 1/3 cup (80 mL))
and pour it into the center compartment labeled
"Liquid Bleach" and marked with this symbol .
Do not exceed the maximum fill line. Overfilling can
cause early dispensing of the bleach which could
result in damaged clothes.
Do not pour undiluted liquid chlorine bleach directly
onto the load or into the drum. Fabric damage can
occur.
Laundry products used with powder or liquid
detergent, such as color-safe bleach, water
conditioner, detergent booster, and enzyme products
should be added to the empty tub before loading.
From time to time you may see water in the
bleach and fabric softener compartments. This is a result
of the siphoning action and is part of the normal
operation of the washer.