Flymo VM032 Lawn Mower User Manual


 
Grassbox
J
Fitting Fully Assembled Grassbox to Lawnmower.
1. Lift safety flap (G1)
2. Make sure the discharge chute is clean and free
from debris (G2)
3. Locate fully assembled grassbox onto 2 location
points (G3) at the rear of the deck as illustrated in
pic. H
4. Locate safety flap onto the top of the grassbox. En-
sure the grassbox is securely located.
IMPORTANT !
AFTER FITTING ENSURE NO GAP REMAINS BE-
TWEEN THE SAFETY FLAP AND THE GRASS-
BOX.
Removal is the reverse procedure.
For larger areas of grass where grass collection is
not required you can use your lawnmower without
the grassbox. Ensure the Safety Flap is fully
closed. The design of the safety flap permits the cut
grass to be discharged downward behind the ma-
chine.
Grassbox Full Window (Visimo Only)
As the grassbox fills up, grass will be visible through
the window (J).
When the window/grassbox is full it is time to empty
the grassbox.
grassbox
empty
grassbox
full
G
1
2
3
H
Visimo Only
Cutting Height Adjustment
Cutting Height Adjustment (K) & (L)
Height of cut is adjusted by raising or lowering the
Front and Rear Wheels.
There are five heights of cut on this product.
NOTE
A medium height of cut is recommended for most
lawns.
The quality of your lawn will suffer and collection will
be poor if you cut too low.
HEIGHT OF CUT WHEELS POSITION
Low Front position 2cm
Rear position 2cm
Low to Medium Front position 2cm
Rear position 4cm
Medium Front position 4cm
Rear position 4cm
Medium to High Front position 4cm
Rear position 6cm
High Front position 6cm
Rear position 6cm
L
K
2cm
6cm
4cm